(1)INSTALLACIONEasy to install
Our Flex Fuel conversion kits are easy to install and are available for almost every fuel injected car on the road.
Imagine your car quickly and easily on fuel E85 ethanol.
1.Connect the adaptor connectors to the injection connectors.
2.Find a cool and dry place, NOT near the exhaust system and radiators-where the heat radiates.
3.Connect ´´– ´´pole (grounding) on the bodywork frame, make sure that ´´-´´ pole is well fastened.
4.The cable with ring is a digital temperature engine sensor for automatic cold start, carefully bolt on engine (engine head) where the current engine temperature is situated,!!!CAUTION!!!- carefully and not on the exhaust pipe.
5.Perform the first start in PETROL MODE!!!
!!! DO NOT PLUG IN ´´+´´ POLE ON THE BATTERY !!!
When the ignition key is switched off, the unit has to be turned off.
WHILE INSTALLING, IT IS SOMETIMES NECESSARY TO FIND THE RIGHT ´´+´´ 15A-20A IGNITION C
ABLE, OUR TECHNICIAN WILL EXPLAIN THIS TO YOU ON PHONE NUMBER. +420 777 978 021!!!
CAUTION !!! Place the unit in a dry and the coldest place away from the engine and exhaust
pipes.Video-Installation version 3.5:
(An example of video-installation version 3.5 without the connection of the ignition +12V and temperature sensor of the engine)
Programming manual part of a package
Video-Programming version 3.5
(An example of video-programming version 3.5)
The unit is programmed with a button on the unit, it is not necessary to use USB
!!!CAUTION!!!For each type of engine, it is necessary to set the unit in order to blend not too lean or too rich. Everything depends on the power and duration of injection of the given engine. A smaller percentage of injection settings on the unit do not necessarily mean lower consumption.
E85 – extends engine life
For cold starts and better engine operation, we recommend Nippon Denso Iridium Power spark plugs
The control unit has 6 modes, 5 of modes can be programmed:
-0.petrol mode – without adjustment of injection (non-programmable)
-1.E70 mode - programmable
-2.E85 mode - programmable
-3.AUTO mode - fully automatic programmable
-4.COLD START mode - AUTOMATIC and MANUAL- programmable
-5.INJECTION TIMING mode- programmable
-sub-mode AUTOMATIC COLD START
-cold starts are adjusted by processor using a digital temperature sensor and calculates enrichment by the current engine temperature from +30°C to -30°C
-sub-mode MANUAL COLD START- cold start can be activated at any time as required by turning the ignition key to II position and waiting 10 seconds before the start (enrichment value is according to the current setting, we recommend 70%). It is necessary to connect the yellow cable to the switch + 12 V after turning the key.
THE PROGRAMMING WILL HELP US TO ACHIEVE OPTIMUM CONSUMPTION SETTINGS FOR YOUR TYPE OF ENGINE